Basic Installation

INSTALLATION

OUR PROCESS

Water Heater Pros specializes in residential and commercial water heater repair and replacement.  We take care of all your water heater needs, including expansion tanks, water shut-off valves, and any other plumbing item related to the water heater.     

 

Our Standard Installation is defined as the "standard installation of a new water heater" in place of an old one in which has a clear access (36" wide) to the old water heater. 

 

Standard Installation of a new water heater includes:

  • We shut-off your water, gas, or electric, and drain and disconnect your old heater

  • We slide it out of the way and put the new one right in the same place.

  • We hook the new water heater up to the existing water lines below the existing valve: 

  • If copper, we remove old copper flex connectors and solder copper male adapters,  we then install stainless steel water flex connections for both the hot and cold fittings at heater.

  • For gas water heaters, we hook it up to the existing flue and install new gas valve and gas pipe drip leg assembly and new gas flex line.

  • For electric water heaters, we reconnect it to the existing electric quick disconnect box. 

  • We check the water pressure and install a new thermal expansion tank and piping.

  • We haul-away the old water heater to be recycled for free.

  • The labor warranty for all new water heater installation is 3- years.  You choose the factory Warranty for the new water heater (warranties typically range from 6 through 12 years).

Some examples of a non-standard installation include:  (1) when the water heater is located on the 2nd floor or above, (2) when the tank is not accessible because it is behind a furnace, (3) when gas lines are blocking it, or (4) when it is behind a finished wall or door frame.

WHAT WE CHECK & WHY YOU SHOULD GO WITH US

  • Water Pressure: Is the water pressure at the water heater acceptable? (Pressure over 80psi can damage your new water heater)

  • Hot Water Supply: Do you currently have enough hot water under normal conditions? Is the existing water heater sized properly?

  • Location: Is the water heater currently installed in a code approved location?

  • Space: Is there adequate space for the new water heater to be installed?

  • Flue Vent Size: Is the existing flue vent adequate for the new water heater?

  • Combustion Air: Is there enough combustion air in the current location? (gas heaters need a sufficient supply of oxygen to operate safely) water heaters in a confined space must have two vents equal to 100 square inches each, for water heaters up to 100,000 BTU.

  • Relocate: Would you like to move the water heater to another area? (any remodeling plans in the future?)

  • Sturdy Stand: Does this installation require an 14″ high stand? Water heaters with unsealed combustion chambers (like many 75 and 100 gallon types) require a stand if they are located in the vicinity of a parked vehicle (typically a garage or near a garage). If there is a stand currently, is it code approved? Is the stand bolted to the floor?

  • Drip Pan: Is the heater in a location that might require or need the installation of a drip pan? This is a metal containment pan with a drain on the side that will help contain any water that might leak out from under the heater. The drain line must then be run to an approved location.

  • Bollard: Is the water heater in a place that would require a bollard? This is a 4″ diameter steel pole placed into the concrete to protect the heater from being hit by a car. 

  • Gas Supply pipe: Is the gas pipe feeding the water heater up to code? Is it properly secured?

  • Emergency Gas Shut-off Valve: Does the emergency shut-off valve for the gas line work easy or is the valve a spring loaded or non compliance.

  • Gas Flex Line: Is there a gas flex line going into the heater? Gas flex lines must be replaced at time of new installation. Any water heater rated at 100,000 B.T.U’s or more requires a special gas flex line or hard pipe.

  • Emergency Water Shut-off Valve: Does the emergency water shut-off valve work? Is it located where it is accessible?

  • Seismic Bracing: Is there code approved seismic bracing in the current installation? If so, is it a dual strap and secured at 4 points?

  • Flue Vent Installation: Is the flue pipe up to code? (this is the pipe that comes out of the top center of the heater and removes the un-burnt gases, carbon monoxide, to the outside) Is it sized properly? Does it work? (we will check) An oversized flue pipe can be a problem and cause condensation that could possibly shorten the life of your heater. Asbestos vents must be removed.

  • Temperature and Pressure Relief Valve: Does the temperature and pressure relief valve terminate in a code approved location? This is a safety valve that all heaters have that will open if the temperature and/or pressure becomes excessive. If this occurs that scalding hot water must go someplace.

  • Hot Water Return Line: Does it take a long time for certain areas of the house to get hot water? Can some type of hot water return system be installed?

  • Tankless Alternative: Is the installation of a tankless heater possible? Tankless gas heaters can be an effective option and should be examined as a viable alternative.

  • Hybrid Heat-Pump: Electric heat pump water heaters are also known as Hybrids and have been designed to be the most energy efficient hot water heater in the industry as high as 3.70EF. current rebates as high as $3000.
  • Energy Star: Energy star water heaters are energy efficient and offer rebates in most areas.

HERE IS WHAT WE INCLUDE   With every professionally installed water heater.

Expansion tank required 

by local code, included

New Stainless Steel Flex

Connections, included

Safety valve & up to 3' of pipe & fittings, included

Gas drip leg assembly 

code required, Included

Gas 24" flexible safety 

connector, included

Copper piping, fittings and adapters, included

Properly fasten flue venting hardware, included

Free haul-away and recycle old water heater

Actual Water Heater Installation by Water Heater Pros

Most common parts bundle as shown above, older homes may need additional work per safety codes.

Get a free quote

Low Price

Guarantee

When Booked Here

WATER-

 HEATERS

SERVICE AREAS 

Antelope   I   Arden Arcade  I  Carmichael  I  Citrus Hights   I  Elk Grove   I  Fair Oaks   Florin Folsom   I  Granite Bay  I  Gold River  I  Loomis  I  Rancho Murieta  I  Natomas  

North Highlands  I  Orangevale  I  Rio Linda  I  Rocklin   I  Rosemont   I   Roseville   Sacramento   West Sacramento   

 

WATER HEATER PRICES 

Gas  I   Electric   I   Tankless   I    Hybrid    I   Commercial   I   Service & Repair 

 Permits Fees  I  Upgrades

 

BUSINESS HOURS

Monday through Friday:  7AM to 7PM

Saturday: 8AM to 2PM

Sunday: Closed

 

CONTACT INFORMATION 

       916-344-4500

        

       info@waterheaterexpert.net

 

Water Heater Pros is a partner company

of Water Heater Experts Corporation

Ca. Lic# 724577     

GET QUICK FINANCING

  • Facebook Social Icon
  • Twitter Social Icon
  • Google+ Social Icon

885 Reviews

 

Click to View

five-star-review.png
5-Star-Business-Yelp-Silverback-Automoti
google-review.png

 Copy Right 2012 - 2019 Water Heater Experts a California Corporation    All Rights Reserved   Corporate Office 9341 Fair Oaks Blvd, Fair Oaks CA  95628